Standard Rules Permits
Before you apply for a standard rules permit make sure you understand the standard rules set, that it describes exactly what you want to do and that you will be able to meet the requirements of the rules.
For each facility there is a set of rules, guidance on how to comply with the rules and a risk assessment.
We may place limits on the proximity of your activity to nature conservation sites or specify whether any point source emissions are allowed.
Applying for a standard permit saves you time and money. However, before you decide to apply you need to be aware of some important characteristics:
- You cannot vary the rules and you have no right of appeal against them;
- If you want to change your operations so that a standard permit no longer works for your operation you will have to apply to change your permit to make it bespoke instead;
- If there is a change in your local environment after your permit has been issued (for example due to a change in the definition of a groundwater source protection zone), you may need to upgrade the operation to a standard sufficient for the changed environment, or apply to change to a bespoke permit
- For standard permit discharges to surface waters, the annual subsistence charge will start from the date the permit is issued. We recommended that you do not apply for a standard permit significantly ahead of when it is required unless you accept payment of these charges. There are currently no standard rules permits for sewage effluent to ground/groundwater
- You should check if we are due to make any changes to the rules before you apply to make sure you will still be able to meet them when the changes are published. If not, you should consider applying for a bespoke permit
If the activity you want to undertake seems to be covered by one of the standard rules at the bottom of this page, select the link and read carefully through the full standard rules set and associated generic risks assessment.
Make sure you understand the standard rules set, that it describes exactly what you want to do and that you will be able to meet the requirements of the rules. If you cannot comply with any of the standard rules, you must apply for a bespoke permit.
Look at our How to apply for an environmental permit page before you apply, for up-to-date information on the application process.
Changes to standard rule permits from October 2018
Rule sets SR2009 No4, SR2012 No10 and SR2012 No12, have been removed for new applicants. If you currently hold one of these rule sets, please contact your site compliance officer for more information.
When opening the forms, you may need to click 'Save and Open', then 'View, Edit document' or 'Enable content'. Look at our How to apply for an environmental permit page for more information on using our application forms.
Please note: Once you have selected the right parts of the form you only need to fill in the sections of that form which are relevant to your application.
If you are having difficulty filling in your application then the information in the 'Help with you application' section, below may help you. If you require some pre application advice please use the contact details below.
Application form Part A - About you
Guidance notes Part A - How to complete Part A of our application form
Application Form Part B1 - Apply for a standard facilities permit
Guidance notes Part B1 - How to complete Part B1 of our application form
Application Form Part F1 - Opra, charges and declarations
Guidance notes Part F1 - How to complete Part F1 of our application form
Help with your application
General enquiries email - firstname.lastname@example.org
General enquiries number 0300 065 3000
Permit Receipt Centre
Natural Resources Wales
29 Newport Road
We'll determine your application as soon as is practically possible. If your application for a permit is more complex because of other legislation or planning constraints, or we have particular concerns about the proposal then we may need to agree a different timescale with you.